Firmware Download

Download the old version

Download Type Firmware
Model name IC-7300
Version Version 1.20
Update Nov.30.2017
Major changes

Changes in this version

  • A combination of [MIC] and [USB] is now selectable as a modulation signal input in the SET MODE item "DATA OFF MOD" and "DATA MOD".
  • English, German and French are now selectable for the Full Keyboard in the new SET MODE item "Full Keyboard Layout".
  • Updated ESP version 70MHz band frequency range to 70.15-70.25MHz.

To update the firmware

  • Thoroughly read Section 8. USING AN SD CARD and Section 15.
    UPDATING THE FIRMWARE of the FULL MANUAL and follow the instructions appeared on the display of the IC-7300.
  • The firmware will be updated to the following versions.
    Main CPU: 1.20
    DSP Program: 1.07
    DSP Data: 1.00
    FPGA: 1.13
Note
File Size 2.68MB
File Type zip
Manual manual download page

Regarding this Download Service.

When using this download service, the implementation, use and/or results of use are the sole responsibility of you using this download service and the equipment. You shall comply with applicable laws and regulatory requirements in the use of this download service and in the operation of the equipment.

Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. and its affiliates expressly denies and is free from any and all responsibility arising from the result of damage from such an event.

You agree not to hold Icom Inc. and its affiliates responsible for any damage to your equipment operation or loss of data, or unauthorized use of the equipment, whether intentional or not, as a result of use this download service.

You need Adobe Acrobat Reader to view these PDF files. If you do not have this installed, please download the software by clicking on the icon at left.
Return to search page