English | Español | Português
Icom America Home

Eclipse2

P25 + Analog

specifications

Specifications

General
Receiver &
Exciter
Pwr Amp PA 501 SMPS-12 PS-12
Weight 1.45 Kg 3.55 Kg 4.65 Kg 2.6 Kg 8.0 Kg
Dimensions
(Width) 2UW=62 mm
(2 716 in.)
2UW 3UW 5UW 2UW 4UW

Mounting Rack

4U high 19 inch 4.55 Kg

Blank Front Panel Available in I UW, 3UW, 4UW width
Power +13.8 Vdc or 120/240 volt, 50/60 Hz ac with SMPS12 power supply or PS12 power supply
Channel Capacity 256 channels BCD coded 0-255

Tone Squelch

Fully programmable, one EIA Tone per channel
Programming Windows® or Linux, through serial port, USB or Ethernet

Software

IP Commander

Test and Diagnostics

Front panel test connector USB via Ethernet and ALM, SQ, TX and PWR LEDs
Audio Response Selectable flat or 750uSec pre/de - emphasis
Audio Interface Standard 600 Ohm 0dBm balanced and Hi- Z unbalanced
Exciters / Transmitters
Frequency spread Full band (Series 150), 10 MHz (Series 500)
Frequency stability ±1 ppm
Power output adjustable 0.5 to 5 Watt
Power regulation ± 10% from 12-16 Vdc, 0 to 50 deg C. all channels
Duty cycle 100% to 40 deg C. temp -30 to +60 C
Carrier and Modulation
Attack time
20 mSec
Spurious and harmonics Less than -36dBm (0.25 uW)
Audio response +1 to -3 dB 300 to 3000 Hz
Audio distortion Less than 3% at 60% system deviation at 1KHz
Residual Hum and Noise
relative to 60% system deviation
Less than -50dB
Audio input level 600 Ohm line, -30 to +10 dBm Hi -Z input, 25 mV to 1 Vms Subtone input compatible with receivers Test microphone, 6 mV ms at 200 Ohms
Remote Keying DC Opto-coupled Input
Exteranl Ref. option Allows the transmitter to be phase locked to an external 1 MHz reference
Diagnotics VCO unlock, tuning voltage, signal strength, external mute, alarms and supply voltage via password protected via IP Commander software
Receivers
Frequency stability 1 ppm standard (TCXO) temp -30 to +60C
Frequency spread for 1dB degradation 38 MHz(Series 150) 10 MHz (Series 500)
Sensitivity 0.25μV (119 dBm) for 12 dB Sinad, 0.35 μV (-119 dBm) for 20 dB Quieting
Spurious and image Rejection 90 dB
Selectivity 80 dB at 25 KHz spacing per RS -204 -C, 75 dB at 12.5 KHz spacing
Intermodulation 80 dB per RS -204-C
Modulation acceptance 7.5 and 3.75 KHz
Squelch software adjustable from 6 to 26 dB Sinad Carrier squelch, adjustable from 1 to 200 μV
Audio response +1 to 3 dB 300 to 3000 Hz
Audio level 600 Ohm line adjustable from -10 to +10 dBm Monitor output, 3 watts at 4 Ohms Discriminator and subtone output 1 V peak at 100% system deviation
Audio distortion Less than 3% at 1KHz, 60% system deviation with 750 uSec de-emphasis
COS output Opto-coupled + 12V, GND and free switch connections
Diagnostics VCO Unclock, tuning voltage, signal strength, external mute, alarms and supply voltage via password protected via IP Commander software
Power Amplifier PA70 PA150 PA500 PA501
Output power (adjustable) 25 to 70 watts 25 to 60 or
50 to 100 watts
25 to 60 watts 50 to 100 watts
Input power (typical) o/p 7 watts at 50 W o/p,
20 watts at 100 W o/p
10 watts at 50 W o/p 12 watts at 100 W o/p
Duty cycle 100% 50W - 100%
100W - 100%
with optional fan
50W - 100% 100W - 100%
with in-built fan
Protection Automatic power reduction with high VSWR and temperature
Spurious and harmonics Less than 0.25μV
DC Power Consumption (DC Amps)
TRX Model Standby (RX active) Full power RX/TX active 100%
TRX150 0.5 2 0.66
R500 0.53 2 0.68
50 Watt PA 100 Watt PA
Tx Model Idle 35W 50W 50W 75W 100W
T150 0.3 5.0 6.2 10.0 12.0 14.4
T500 0.2 4.4 4.8 12.0 15.0 17.6
Protection Note: For a repeater or base station Add TRX and PA currents for a total figure
SMPS12-2
(13.8V 35 Amps
Idle Tx ON PA ON
Switch Mode Rx Rx/Tx Rx/Tx/PA 15W 25W 50W 100W
0.15 0.18 0.21 0.21 0.67 0.58 1.22 2.14
PS12
(13.8 V 20 Amps)
Idle Tx ON PA ON
Linear Rx Rx/Tx Rx/Tx/PA 15W 25W 50W 100W
0.021 0.08 0.11 0.11 0.67 0.75 1.37 2.35

 

View our blog