English | Español | Português
Icom America Home

IC-F9511 / F9521 Series

VHF P25 Conventional & Trunked Transceivers

specifications

Specifications

General
Frequency coverage

F9511 T/S 136–174 MHz
F9521 T/S 400-470, 450-512 MHz

Number of channels Max. 512 channels/ 128 zones
Power supply requirement 13.6V DC nominal

Current drain (approx.)

Tx High (50W) 11..0A/14.0A (VHF/UHF)
Rx Max. Audio 1000mA
Stand-by 350mA
Operating temperature range –30°C to +60°C; –22°F to +140°F
Antenna impedance 50Ω (SO-239)
Dimensions (W×H×D)

175×45×170mm;

678×12532×61116in

Weight

1.5kg; 3.3lb

Rated output power 50W
Channel spacing 15/30 kHz (VHF), 12.5 kHz (UHF) (analog)
12.5 kHz (digital)
Transmitter
Audio output power 4W typical at 10% distortion with a 4Ω load
Max. frequency deviation
Maximum pattern
Minimum pattern
±5.0/2.5 kHz (Wide/Narrow)
±2.85 kHz (Digital)
±0.95 kHz (Digital)
Frequency error ±1.0ppm
Spurious emissions 70dB min.
Adjacent channel power 70/60dB min (wide/Narrow)
67dB min. (Digital)
FM hum and noise 48/45dB typ. (VHF, Wide/Narrow)
48/43dB typ. (UHF, Wide/Narrow)
Audio harmonic distortion 3% typ. (40% deviation)
External microphone impedance 600Ω (8-pin modular)
Receiver
Sensitivity
Analog
Digital
0.25μV typ. (at 12dB SINAD)
0.25μV typ. (at 5% BER)
Squelch sensitivity 0.25μV typ. (at threshold)
Adjacent Ch. selectivity
Analog (TIA/EIA603B)
(TIA/EIA603)
Digital
81/53dB typ. (VHF, Wide/Narrow)
79/53dB typ. (UHF, Wide/Narrow)
63dB typ.
Spurious  response 85dB min. (VHF)
70dB* min. (UHF)
*85dB min (406. 1-420 MHz)
Intermodulation 78dB typ.
Audio output power
External audio (D-sub)
4W typ.
22W typ.
at 10% distortion with a 4Ω load
Hum and noise ratio 55/51dB typ. (VHF, Wide/Narrow)
30/45dB typ. (UHF, Wide/Narrow)
52dB typ. (Digital)
External speaker connector 2-conductor 3.5 (d) mm (18″)/4Ω

Applicable U.S. Military Specifications

Icom makes rugged products that have been tested to and passed the following MILSTD requirements and strict environmental standards.

Standard MIL 810 F
Method Proc
Low Pressure 500.4 I, II
High Temp. 501.4 I, II
Low Temp. 502.4-3 I, II
Temp. Shock 503.4 I
Solar Radiation 505.4 I
Humidity 507.4
Salt Fog 509.4
Dust Blowing 510.4 I
Vibration 514.5 I
Shock 516.5 I, IV

Also meets equivalent MIL-STD-810-C, -D and -E.
Ingress protection standard: Dust and water: IP54* (Dust-protection and water resistant)
*IP54 test were performed on the controller and RMK-2 only.

Measurements made in accordance with TIA-102 (Digital), TIA-603B (Wide/narrow). All stated specifications are subject to change without notice or obligation.

Supplied Accessories

  • Hand mic. (HM-148)
  • Microphone hanger
  • External speaker, SP-22
  • DC power cable
  • Key assign stickers
  • Mounting bracket kit